帧中继的主要命令

帧中继交换机配置
R4(config)#frame-relay switching//启用frame-relay
R4(config)#interface serial 1/0
R4(config-if)#encapsulation frame-relay
R4(config-if)#frame-relay intf-type dce
R4(config-if)#frame-relay lmi-type cisco
R4(config-if)#frame-relay route 100 interface serial 1/1 101//帧中继内部交换
R4(config-if)#clock rate 64000
R4(config-if)#no shutdown
R4(config-if)#exit
R4(config)#interface serial 1/1
R4(config-if)#frame-relay lmi-type ansi
R4(config-if)#frame-relay route 101 interface serial 1/0 100
R4(config-if)#clock rate 64000
R4(config-if)#no shutdown
R4(config-if)#exit
客户端动态配置
IOS版本高于11.2的配置
R1(config)#interface serial 1/2
R1(config-if)#encapsulation frame-relay//在接口下启用帧中继的封装
R1(config-if)#ip address 172.16.1.1 255.255.255.0
R1(config-if)#no shut
IOS版本低于11.2的配置
R2(config)#interface serial 1/2
R2(config-if)#encapsulation frame-relay
R2(config-if)#frame-relay lmi-type ansi//在接口下指定frame-relay封装类型
R2(config-if)#ip address 172.16.1.2 255.255.255.0
R2(config-if)#no shut
验证：
R2#show frame-relay map
Serial1/2 (up): ip 172.16.1.1 dlci 101(0×65,0×1850）,dynamic,
broadcast,,status defined,active
R2#